Abstract
AbstractEstimating of soil sorptivity () and saturated hydraulic conductivity () parameters by field infiltration tests are widespread due to the ease of the experimental protocol and data treatment. The analytical equation proposed by Haverkamp et al. (1994) allows the modelling of the cumulative infiltration process, from which the hydraulic parameters can be estimated. This model depends on both initial and final values of the soil hydraulic conductivity, initial soil sorptivity, the volumetric water content increase () and two infiltration constants, the so‐called and parameters. However, to reduce the number of unknown variables when inverting experimental data, constant parameters such as and are usually prefixed to 0.6 and 0.75, respectively. In this study, the values of these constants are investigated using numerical infiltration curves for different soil types and initial soil water contents for the van Genuchten‐Mualem (vGM) soil hydraulic model. Our new approach considers the long‐time expansions of the Haverkamp model, the exact soil properties such as , and initial soil moisture to derive the value of the and parameters for each specific case. We then generated numerically cumulative infiltration curves using Hydrus‐3D software and fitted the long‐time expansions to derive the value of the and parameters. The results show that these parameters are influenced by the initial soil water content and the soil type. However, for initially dry soil conditions, some prefixed values can be proposed instead of the currently used values. If an accurate estimate of and is the case, then for coarse‐textured soils such as sand and loamy sand, we propose the use of 0.9 for both constants. For the remaining soils, the value of 0.75 can be retained for . For constant, 0.75 and 1.5 values can be considered for, intermediate permeable soils (sandy loam and loam) and low permeable soils (silty loam and silt), respectively. We clarify that the results are based on using the vGM model to describe the hydraulic functions of the soil and that the results may differ, and the assumptions may change for other models.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.