Abstract

The aim of this preliminary prospective RCT was to histologically evaluate peri-implant soft tissues around titanium abutments treated using different cleaning methods. Sixteen patients were randomized into three groups: laboratory customized abutments underwent Plasma of Argon treatment (Plasma Group), laboratory customized abutments underwent cleaning by steam (Steam Group), and abutments were used as they came from industry (Control Group). Seven days after the second surgery, soft tissues around abutments were harvested. Samples were histologically analyzed. Soft tissues surrounding Plasma Group abutments predominantly showed diffuse chronic infiltrate, almost no acute infiltrate, with presence of few polymorphonuclear neutrophil granulocytes, and a diffuse presence of collagenization bands. Similarly, in Steam Group, the histological analysis showed a high variability of inflammatory expression factors. Tissues harvested from Control Group showed presence of few neutrophil granulocytes, moderate presence of lymphocytes, and diffuse collagenization bands in some sections, while they showed absence of acute infiltrate in 40% of sections. However, no statistical difference was found among the tested groups for each parameter (p > 0.05). Within the limit of the present study, results showed no statistically significant difference concerning inflammation and healing tendency between test and control groups.

Highlights

  • Pure titanium (CP-Ti) and titanium alloy Ti-6Al-4V are widely used for dental implant abutments

  • Microgrooves can be observed on the milled surface of the titanium abutments

  • The aim of this study was to histologically compare the peri-implant soft tissue response to titanium abutments characterized by different surface cleaning treatments

Read more

Summary

Introduction

Pure titanium (CP-Ti) and titanium alloy Ti-6Al-4V are widely used for dental implant abutments. Titanium and its alloys provide higher strength, rigidity, and ductility compared to other dental alloys. Due to increased esthetic requirements and procedure standardizations, the use of customized instead of prefabricated titanium abutments has been promoted. Abutment customization can be realized in laboratory or by CAD-CAM procedures. Microgrooves can be observed on the milled surface of the titanium abutments. These microgrooves could result in accumulation of contaminants/debris

Objectives
Methods
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call