Soft Self-Regulating Heating Elements for Thermoplastic Elastomer-Based Electronic Skin Applications.

Abstract

Resistive heating elements can be of particular interest for many applications, such as e-skin. In this study, soft heating elements were developed by combining thermoplastic polyurethane (TPU) with carbon black. In contrast to previous studies on thermoplastic polymer-based thermistors, the heating elements could endure elongations above 100%. Due to the high melting point of the TPU and the carbon filler, the thermistors could be heated up to 180°C without significant deformation. The heating elements were extruded on TPU substrates using material extrusion additive manufacturing in one-step process. Self-regulating behavior to control the maximum temperature was achieved with the application of two different voltages (20 and 25 V) and different current thresholds, between 100 and 800 mA. The heating performance was adjusted by changing the geometry of the sensing elements; an increase in cross section resulted in a lower current density and lower temperature. For the heating elements, variation of the additive manufacturing parameters such as offset, layer height, nozzle speed, and extrusion multiplier resulted in a different width/height aspect ratio of the cross section of the extruded lines, affecting the initial resistivity of the thermistor. Orientation of the carbon filler during extrusion process is one reason for the small change of the longitudinal conductivity of the heating elements. The resulting skin with the integrated heating elements allowed the possibility to perform the in situ heating for the localized healing of structural damage, while maintaining the softness required for the application of soft robotic electronic skin.