Abstract
This paper proposes a new concept of a smart damper using the combination of magnetic friction and rubber springs. The magnet provides energy dissipation, and the rubber springs with precompression contribute to increasing the recentering capacity of the damper. To verify their performance, dynamic tests of magnet frictional dampers and precompressed rubber springs were conducted. For this purpose, hexahedron neodymium (NdFeB) magnets and polyurethane rubber cylinders were used. In the dynamic tests, the loading frequency was varied from 0.1 to 2.0Hz. The magnets showed almost perfect rectangular behavior in the force–deformation curve, and the frictional coefficient of the magnets was estimated through averaging and regression. The rubber springs were tested with and without precompression. The rubber springs showed different loading path from the second cycle and residual deformation that was not recovered immediately. The rubber springs showed greater rigid force with increasing precompression. Finally, this paper discusses the combination of rigid-elastic behavior and friction to generate ‘flag-shaped’ behavior for a smart damper and suggests how to combine magnets and rubber springs to obtain flag-shaped behavior. The performance of the magnets and precompressed rubber springs was verified through analytical models.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.