Abstract

Conventional single photon emission computed tomography (SPECT) collimators are not suitable for 511keV imaging. In order to use a SPECT system for single positron emission tomography (SPET), we need to design high-efficiency collimators capable of absorbing 511keV photons. Slit slat (SS) collimators have been proposed for this purpose even though the optimization of such collimators has not yet been performed. In order to investigate the reliability of the system with SS collimator, it was decided to evaluate such a system.A gamma camera system with both parallel hole (PH) and SS collimators was simulated by Monte Carlo method. In these simulation parameters of the simulated system having 38in NaI(Tl) crystal for 140keV γ-rays with PH collimator was compared with practical results and a good correlation was found between the simulated and practical results. In this way, the validity of our simulation code was confirmed. The crystal thickness for simulated γ-camera system with SS collimator for detection of 511keV photons was set to be 58in which resulted in an intrinsic spatial resolution of 4mm. The simulated SS collimators consisted of 50 lead plates of various height, thickness and spacing. The imaging was performed by rotating the SS collimator from 0° to 180° in 73 steps of 2.5° each. The physical parameters such as spatial resolution, efficiency and modulation transfer function (MTF) of this system for different SS collimator designs, (i.e. SS64,3,3, SS80,3,3, SS64,4,5, SS80,4,5, SS85,4,5, where in SSh,s,t is used to indicate the septal height (h), septal separation (s), and septal thickness (t) in millimeters were evaluated. The value of these parameters were compared with the values obtained employing a 511keV PH85,4,2.5 collimator.Based on MTF values, our result showed that the SS85,4,5 collimator has an optimum performance to the other SS collimators. The relative efficiency of the system with SS85,4,5 collimator was about 20 times higher than the efficiency of the system with the PH85,4,2.5 collimator whereas in this case the spatial resolution had deteriorated by almost 8% (i.e. from 14.1 to 15.0mm).The result of this study shows that the SS collimators have great advantages over the conventional PH collimators for 511keV imaging, providing much higher efficiency while maintaining a comparable spatial resolution. Employing this collimator makes it possible to use a SPECT system for metabolic imaging by SPET system.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call