Abstract
Dislocation transmission through α/β phase boundaries in titanium alloys is studied using integrated crystal plasticity (CP) and discrete dislocation plasticity (DDP) modelling techniques, combined with experimental micro-pillar compression test results. Direct dislocation transmission together with the nucleation of new dislocations ahead of a pile-up at an α/β interface, termed indirect slip transfer, are both assessed and their role in controlling microstructure-dependent strain rate sensitivity considered. A critical shear stress criterion for direct slip transfer across an α/β interface in Ti-6242 has been established by capturing the local slip penetration through the phase boundary using CP and DDP comparisons with experimental two phase micro-pillar compression. The competition between direct and indirect slip transfer has been investigated using a single Frank-Read source DDP model. Direct slip transfer is found to occur only under specific conditions which have been quantified. The strain rate sensitivity of dual phase titanium alloys is demonstrated to depend on average pile-up size which is significantly influenced by α/β morphology.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.