Abstract
In this study, the effects of the rake angle on main cutting force (Fc), and thrust forces (Ft) was investigated. A new slip line model approach for modelling the orthogonal cutting process was proposed. This model was applied at negative rake angles from 0° to –60° and consists of three regions. The main forces were measured with a computer aided quick stop device. Variance Analysis (ANOVA) was utilized to analyze the effects of the cutting parameters on cutting and thrust forces accordingly. Multi-variable regression analysis was also employed to determine the correlations between the factors and the cutting forces. The cutting forces could be calculated by equation parameters which are the rake angle and the uncut chip thickness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transactions of the Canadian Society for Mechanical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
