Abstract
Sliding wear behavior of sintered alumina with grain sizes between 0.45 and 4 microm was studied in bovine serum environment with unidirectional pin-on-disc wear testing machine. Submicron grained alumina of average grain size of G=0.45 microm exhibits lowest wear factor among the others. It was found that grain pull out or localized grain dislodgement caused by coalescence of grain boundary microcracks is the basic wear mechanism of submicron grained alumina though the extent of cracking and pull-out was substantially less than that with higher grained material. However, in few cases, some areas where substantial volume of material was removed following pull-out of cluster of grains have also been observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
