Abstract
Purpose The purpose of this technical paper is to investigate the friction and wear behavior of inexpensive and durable cutting tools, developed for wood machining using duplex treatment. Design/methodology/approach Cr–(WC–Co) coatings were deposited onto carburized low-alloy steel substrate by a reactive magnetron sputtering. The total coating thickness was approximately 2 μm. Unlubricated wear tests have been performed using a disc sample sliding against an alumina ball (Al2O3) and a wood (beech) pin. Findings The paper provides information about the effect of duplex treatment on the surface properties of low-alloy steel against wood and offers practical help for the researchers in coating topic. Originality/value Experimental results showed that sliding wear properties of the selected coatings are strongly dependent on the counter-face material. When tested against alumina balls, the wear mechanisms are oxidative wear followed by a combination of adhesive and abrasive wear, while a combination of an oxidative and adhesive wear was the main wear mechanism observed against a wood pin.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
