Sliding wear and solid particle erosion response of aluminium reinforced with tungsten carbide nanoparticles and aluminide particles

Abstract

AbstractIn the present effort, aluminium matrix composites (AMCs) were produced by the addition of submicron‐sized WC particles of low (up to 2.5 vol%) content into a melt of Al1050. Casting was assisted by the use of K2TiF6 as a wetting agent and mechanical stirring in order to limit particle clustering. Particle distribution was reasonably uniform comprising both clusters and isolated particles. Various different reinforcing particles' phases were identified, both in situ (Al‐W, Al‐Ti, and Al‐W‐Ti intermetallic phases) and ex situ (WC particles) of various morphologies shapes and sizes. Increase of the reinforcing particle content led to an increase of the tendency for clustering. The wear properties of the composite were examined by dry sliding wear. The worn surfaces and the produced debris were examined by SEM‐EDX, and an effort to correlate the wear response of the produced materials with the matrix and the reinforcing phase characteristics was attempted. In general, the increase of the reinforcing phase content led to an improvement of the sliding wear response. Solid particle erosion experiments were carried out for impact angles of 30°, 60°, and 90°. Τhe eroded surfaces were examined with SEM‐EDX, and possible erosion mechanisms were proposed based on morphological and other material characteristics. Intensive particle clustering seemed to deteriorate the erosion resistance of the systems. Medium concentrations of the reinforcing particles (1.0‐1.5 vol% WC) are proposed as a recipe for optimum sliding wear and solid particle erosion resistance behavior.