Skin dose alarm levels in cardiac angiography procedures: is a single DAP value sufficient?

Abstract

Maximum estimated skin doses to patients undergoing coronary angiography procedures were obtained using radiographic slow film and diode dosemeters. Conversion factors of maximum entrance skin dose versus dose-area product (MESD/DAP) for diagnostic (coronary angiography (CA); 20 patients; 2 operators) and interventional procedures (percutaneous transluminal coronary angiography (PTCA); 10 patients; 1 operator) were 4.3 (mean value of 10 CA; operator A), 3.5 (mean value of 10 CA; operator B) and 9.7 (mean value of 10 PTCA; operator B) mGy(Gycm2)(-1), respectively. The results emphasise a need for both operator- and procedure-specific conversion factors. Compared with a single, global factor for all cardiac procedures and/or operators that is commonly applied today, such a refinement is expected to improve the accuracy in skin dose estimations from these procedures. Consequently, reference DAP values used in the clinic to define patients who could suffer from a radiation induced skin injury following a cardiac procedure, should be defined for each operator/procedure. The film technique was found to be superior to the diode in defining conversion factors in this study, and allowed for a rapid and accurate estimation of MESD for each patient. With appropriate positioning of the diode, a combined film/diode technique has a potential use in the training of new angiography operators. The patient body mass index (BMI) value was a good indicator of the variation in average lung dose (critical organ) between patients. The highest lung dose/DAP value was obtained for normal sized patients (BMI: 19-26), and was close to 1.5 mGy(Gycm2)(-1) with both CA and PTCA procedures.