Abstract
To compare skeletal and dentoalveolar measurements of subjects with unilateral impacted canine versus the non-impacted contralateral side using cone beam computed tomography (CBCT). 30 CBCTs with unilaterally impacted maxillary canines (Buccal=15, Palatal=15) were selected. Skeletal and dentoalveolar variables (alveolar ridge height of incisors, dentoalveolar height, angulations of incisors and canines, basal lateral width and premolar width) were compared between the impacted and the contralateral sides. Independent t-test was used to compare the variables. There was a significant difference in the mean basal lateral width between the impacted (28.25±1.83 mm) and non-impacted (31.64±2.18 mm) sides. Premolar width was significantly lower on the impacted side (p<0.05). The canines exhibited significantly greater angulations on the impacted side compared to the nonimpacted side. The basal lateral width was significantly higher in the buccal subgroup (29.03±1.65mm) compared to palatal (27.48±1.70mm) on the impacted side. The intra-operator reliability was found to be high (0.99%). Significant differences were seen in canine angulation, premolar width and basal lateral width between impacted vs. non impacted sides. Basal lateral width was higher in buccal impacted cases compared to palatal.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.