Abstract

Abstract. Additional size-resolved chemical information is needed before the physicochemical characteristics and sources of airborne particles can be understood; however, this information remains unavailable in most regions of China due to lacking measurement data. In this study, we report observations of various chemical species in size-segregated particle samples that were collected over 1 year in the urban area of Beijing, a megacity that experiences severe haze episodes. In addition to fine particles, high concentrations of coarse particles were measured during the periods of haze. The abundance and chemical compositions of the particles in this study were temporally and spatially variable, with major contributions from organic matter and secondary inorganic aerosols. The contributions of organic matter to the particle mass decreased from 37.9 to 31.2 %, and the total contribution of sulfate, nitrate and ammonium increased from 19.1 to 33.9 % between non-haze and haze days, respectively. Due to heterogeneous reactions and hygroscopic growth, the peak concentrations of the organic carbon, cadmium and sulfate, nitrate, ammonium, chloride and potassium shifted from 0.43 to 0.65 µm on non-haze days to 0.65–1.1 µm on haze days. Although the size distributions of lead and thallium were similar during the observation period, their concentrations increased by a factor of more than 1.5 on haze days compared with non-haze days. We observed that sulfate and ammonium, which have a size range of 0.43–0.65 µm, sulfate and nitrate, which have a size range of 0.65–1.1 µm, calcium, which has a size range of 5.8–9 µm, and the meteorological factors of relative humidity and wind speed were responsible for haze pollution when the visibility was less than 10 km. Source apportionment using Positive Matrix Factorization showed six PM2.1 sources and seven PM2.1–9 common sources: secondary inorganic aerosol (25.1 % for fine particles vs. 9.8 % for coarse particles), coal combustion (17.7 % vs. 7.8 %), biomass burning (11.1 % vs. 11.8 %), industrial pollution (12.1 % vs. 5.1 %), road dust (8.4 % vs. 10.9 %), vehicle emissions (19.6 % for fine particles), mineral dust (22.6 % for coarse particles) and organic aerosol (23.6 % for coarse particles). The contributions of the first four factors and vehicle emissions were higher on haze days than non-haze days, while the reverse is true for road dust and mineral dust. The sources' contribution generally increased as the size decreased, with the exception of mineral dust. However, two peaks were consistently found in the fine and coarse particles. In addition, the sources' contribution varied with the wind direction, with coal and oil combustion products increasing during southern flows. This result suggests that future air pollution control strategies should consider wind patterns, especially during episodes of haze. Furthermore, the findings of this study indicated that the PM2.5-based data set is insufficient for determining source control policies for haze in China and that detailed size-resolved information is needed to characterize the important sources of particulate matter in urban regions and better understand severe haze pollution.

Highlights

  • Particulate matter (PM) is among the most important atmospheric pollutants that negatively affect human health and visibility

  • The present level of PM2.1 is significantly lower than that in 2009–2010 (135 μg m−3; Zhang et al, 2013b), it was more than 3 times higher than the National Ambient Air Quality Standard (NAAQS), which specifies an annual average PM2.5 of 15 μg m−3 (GB3095-2012, Grade I)

  • Haze is defined as a weather phenomenon in which a high concentration of fine particles occur that result in a visibility of less than 10 km at an relative humidity (RH) of less than 90 % (Sun et al, 2006; Tan et al, 2009; Zhuang et al, 2014)

Read more

Summary

Introduction

Particulate matter (PM) is among the most important atmospheric pollutants that negatively affect human health and visibility. Tian et al.: Size-resolved source apportionment of particulate matter gans, 2014; Pan et al, 2013). Previous studies have provided valuable information regarding the physical and chemical characteristics of PM in urban Beijing and its surrounding areas (Li et al, 2013; Du et al, 2014; Song et al, 2006; Chan et al, 2005; Schleicher et al, 2013; Sun et al, 2004), the factors that influence haze formation remain unclear due to its complexity (Yang et al, 2014; Jing et al, 2014). Previous studies have primarily focused on single particle fractions, such as PM2.5, and have neglected size-resolved chemical information, especially for coarse particles, which play an important role in haze events (Tian et al, 2014; Sun et al, 2013)

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call