Abstract

Microphysical and chemical aerosol properties and their influence on cloud formation were studied in a field campaign at the high-alpine site Jungfraujoch (JFJ, 3580 m asl). Due to its altitude, this site is suitable for ground-based in-cloud measurements, with a high cloud frequency of 40%. Dry total and interstitial aerosol size distributions [18 nm <particle diameter (Dp)<800 nm] were determined with a time resolution of 6 min. A forward scattering spectrometer probe (FSSP-100) measured the cloud droplet size distribution, and a particle volume monitor (PVM-100) was used to measure liquid water content (LWC). In addition, the aerosol chemical composition (major soluble ions) was determined in two size classes (total and sub-micron particles). Agreement within the range of measurement uncertainties was observed between the droplet number concentrations derived from the aerosol size distribution measurements (total minus interstitial) and those measured by the FSSP. The observed particle diameter at 50% activation (D50) was typically around 100 nm for LWC > 0.15 g m−3. Below this value, D50 increased with decreasing LWC. A dependence of D50 on the accumulation mode (Dp>100 nm) number concentration (Ntot,Dp>100) was only found for concentrations less than 100 cm−3. For higher values of Ntot,Dp>100 the D50 remained constant. Furthermore, a decrease of the effective radius of cloud droplets (Reff) with increasing Ntot,Dp>100 was observed, providing experimental evidence for the microphysical relation predicted by the Twomey effect. A modified Köhler model was used to quantify the critical supersaturation for the aerosol observed at the JFJ. Ambient supersaturations were determined from the derived supersaturation curve and the calculated D50. As an example, a critical supersaturation of 0.2% was found for 100 nm particles.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.