Size Reduction of a MMIC Direct Up-Converter at 44 GHz in Multilayer CPW Technology Using Thin-Film Microstrip Stubs Loading

Abstract

This paper proposes a novel compact multilayer 44.5-GHz coplanar waveguide (CPW) single-sideband (SSB) subharmonically pumped (SHP) mixer for direct up-conversion GaAs monolithic microwave integrated circuit. It uses previously developed thin-film microstrip (TFMS) and CPW structures for capacitive and inductive loading techniques to drastically reduce its size. The SSB SHP mixer uses 50-MHz in-phase and quadrature signals to directly modulate the second harmonic of a 22.25-GHz carrier to produce the required 44.55-GHz RF output. Two pairs of antiparallel diodes reduce feedthrough of the fundamental 22.25-GHz signal to the RF output while novel CPW/TFMS-based structures provide matching. This 1.2times1.5 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> chip uses a lumped Wilkinson divider as a local-oscillator divider and a previously developed reduced size 90deg coupler. The SSB SHP mixer acts as an up-converter with a measured conversion gain of -10plusmn1 dB and the lower sideband suppression is greater than 23 dB across the RF bandwidth of 43.5-45.5 GHz. Additionally, it is shown that the RF port return loss is better than 20 dB, and 2timesf <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">LO</sub> was suppressed by 21 dB over the same band. The circuit also does not require any dc bias. Compared to the conventional SSB SHP mixer, a 70% reduction in circuit area was achieved with better performances