Size-controllable zinc oxide nanowires fabricated via the combination of die-casting and oxidation process

Abstract

Herein, we demonstrate a facile approach in the fabrication of one-dimensional ZnO nanowires (NWs) from the vacuum die-casting method in assistance with anodic aluminum oxide (AAO) template. The casting method enables molten Zn to embed uniformly over the AAO nanomould under high pressure and temperature of 500 °C. Besides, the significant influence of the oxidation time and temperature stimulates the ZnO NWs growth inside the AAO nanochannels. The oxidation in the nanochannels was profoundly controlled by the inward diffusion of oxygen atoms and the ZnO grows perpendicular towards the surface which obeys the parabolic law. The TEM and XRD results revealed the ZnO wurtzite crystalline structure with preferential orientation along the c-axis. The relationship between ZnO geometry and function of oxidation parameters is demonstrated by microscopic and spectroscopic analysis. The obtained NWs from the chemical etching process resulted in high crystalline, homogeneous, and high-aspect ratio ZnO NWs in relationship with the AAO pore dimension. Further, the as-prepared ZnO NWs electrical properties were measured in a four-electrode system through the single nanowire device fabricated by FIB. The obtained current-voltage characteristic curves exhibited hysterias loop in consequence with the space charge limited current effect of ZnO NW, which confirms its potential to be used in practical electronic applications.