Sintering of glass matrix composites with small rigid inclusions

Abstract

We investigated the effect of dispersed crystalline particle volume content Φ on sintering of glass matrix composites (GMC) for low-temperature co-fired ceramics (LTCC) applications. Such composites typically consist of alumo-borosilicate glass and α-Al 2O 3 powders of similar average particle size ( D 50 ≈ 3 μm). Sintering shrinkage was observed by dilatometry and heating microscopy and was backed up by glass viscosity measurements. Microstructure analysis revealed that α-Al 2O 3 particles do neither show significant dissolution into the liquid phase nor detectable crystallization throughout LTCC firing schedules. Therefore, in this study α-Al 2O 3 particles were treated as small rigid inclusions. It was found that Φ lowers the shrinkage rate of GMC. While the lowering is small for small Φ and at the early stage of densification it progressively increases during sintering, and final shrinkage shifts up to 170 K to higher temperatures for Φ = 0.45. The behaviour observed could be explained assuming that sintering is controlled by the effective viscosity, which progressively increases non-linearly during densification due to the gradually wetting of the surface area of corundum particles. We could demonstrate that Al 2O 3 cluster can cause residual pores and reduce the attainable shrinkage. The reduction of attainable shrinkage is found to depend on Φ 3, reaching about 8% at Φ = 0.45.