Abstract
AbstractThe techniques used in alloying in iron powder metallurgy have been extended by employing special compounds. The introduction of the alloying elements in this form and the decomposition of selected nitrides and silicides are described. Elements that oxidize readily at high temperatures (e.g. Cr, Si) can be added in a relatively pure and homogeneous state. These elements stabilize the α phase and thus improve the sintering behaviour.The paper deals mainly with the preparation of binary Fe-Cr, Fe-Si, and also ternary Fe-Cr-Si alloys obtained by ‘in situ’ decomposition of Si3N4, Cr2N, and CrSi2 in an iron matrix (WP-150).The study covers the properties of the powders and their mixtures, the pressing and sintering conditions, the sintering behaviour in the range 1000–1300°C with varying alloying additions, for different sintering times and atmospheres. The tensile strengths observed are ∼525 N/mm2 at a densityof 6·7 g/cm3, with ∼3% elongation at fracture. With respect to the low density and the carbon...
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
