Abstract
ABSTRACTObtaining uniformly dispersed SWNT within an aqueous mixture for subsequent use as a dried coating in electronic biosensors is a challenge. The objective of this study is to relate SWNT dispersion conditions to resultant dried film properties. Aqueous solutions of SWNT dispersed with CMC (a dispersing agent with unique properties compatible with biomolecules) at different SWNT:CMC weight ratios and at different sonication conditions were studied. Solution particle size distribution data was obtained using dynamic light scattering. Differently formulated/processed SWNT/CMC solutions were used to form dry thin, conductive films. The resistance of each film was measured and its resistivity calculated. Response Surface Methodology (RSM) design of experiments (DOE) analysis was used as the tool to fit the data to establish a model and identify trends for the parameters studied. Profilometry was used to examine film surface uniformity. 3D optical microscopy was used to investigate film morphology and determine film thickness, and to relate these data back to solution dispersion conditions and dried film resistances. The lowest dried film resistivity (0.012 ohm-cm) was obtained at the highest levels of parameters studied in the DOE. Smaller solution particle size resulted in lower dried film surface roughness and better film uniformity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have