Abstract
In this paper a compact narrow band pass filter has been designed. An H-shape section of microstrip is used to get the smaller band width. The parallel lines are connected to the H section. The periodic slots are made on the ground plane of the microstrip. These defects cause the circuit more compact. The filter has been designed for center frequency 4 GHz and fractional band width 3%. The design methodology has been clearly explained. To verify the proposed technique, a filter has been fabricated and tested. A moderate matching of the results between the measured and simulated results has been observed due to some imperfection in fabrication.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.