Abstract
Low-cost accelerometers could be used in applications where extremely good characteristics are not a requirement. This paper presents an accelerometer fabricated using printed circuit board (PCB) processing techniques, and laser ablation. Laser is used to remove part of the PCB substrate, releasing a mass suspended by copper beams. The structure is easily bonded to another PCB, creating a variable parallel-plate capacitor with a small gap, which capacitance varies with the movement of the mass, caused by external acceleration. The fabricated accelerometer has been compared to a commercial silicon one, showing good agreement in the measurements. The measured sensitivity was 81fF/g.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
