Simultaneously enhancing strength and ductility of high-Nb-containing TiAl alloy via extrusion-assisted microstructure tailoring

Abstract

In most metallic materials, the strength-ductility trade-off serves as an inevitable scenario. Therefore, improving the room/high-temperature strength/ductility of high Nb-TiAl alloys based on a lamellar microstructure is important for practical applications. In this work, a novel microstructure with fine lamellar colonies and a certain number of residual γ grains was developed through hot extrusion in the near α phase region. The results indicated that the lamellar colony size and spacing of the as-cast alloy were significantly refined by hot extrusion. The as-extruded Ti-45Al-8Nb-(W, B, Y) alloy demonstrated a good combination of high strength and ductility. The tensile strength and ductility were 1129 MPa and 2.04% at room temperature (RT), respectively, and 744 MPa and 51.20%, respectively, at 850 °C. A simultaneous improvement in strength and ductility below ductile-brittle transition temperature (DBTT) could be attributed to the abundant deformation twins and their intersections, as well as prominent strain working caused by high-density dislocations in the γ phase. Due to dynamic recrystallization, the ductility was significantly enhanced when stretched over DBTT. This extrusion-assisted microstructure tailoring strategy could be extended to other TiAl systems and may serve as a useful solution for addressing the significant engineering constraints posed by the low RT ductility and poor hot-working capabilities of high Nb-TiAl alloys.