Simultaneous Removal of Organic Matter and Nutrients from High Strength Organic Wastewater Using Sequencing Batch Reactor (SBR)

Abstract

Industrial wastewater discharges often contain high levels of organic matter and nutrients, which can lead to eutrophication and constitute a serious hazard to receiving waters and aquatic life. The purpose of this study was to examine the efficacy of using a sequencing batch reactor (SBR) to treat high-strength organic wastewater for the removal of both chemical oxygen demand (COD) and nutrients (nitrogen and phosphorus). At a constant COD concentration of approximately 1000 mg/L, the effects of cycle time (3 and 9 h) and various C:N:P ratios (100:5:2, 100:5:1, 100:10:1, and 100:10:2) were investigated using four identical SBRs (R1, R2, R3, and R4). According to experimental data, a significant high removal, i.e., 90%, 98.5%, and 84.8%, was observed for COD, NH3-N, and PO43−-P, respectively, when C:N:P was 100:5:1, at a cycle time of 3 h. Additionally, when cycle time was increased to 9 h, the highest levels of COD removal (95.7%), NH3-N removal (99.6%), and PO43−-P removal (90.31%) were accomplished. Also, in order to comprehend the primary impacts and interactions among the various process variables, the data was statistically examined using analysis of variance (ANOVA) at a 95% confidence level, which revealed that the interaction of cycle time and C/N ratio, cycle time and C/P ratio is significant for COD and NH3-N removal. However, the same interaction was found to be insignificant for PO43−-P removal. Sludge volume index (SVI30 and SVI10) and sludge settleability were studied, and the best settling was found in R3 with SVI30 of 55 mL/g after 9 h. Further evidence that flocs were present in reactors came from an average ratio of SVI 30/SVI 10 = 0.70 after 9 h and 0.60 after 3 h.