Simultaneous removal of atrazine and organic matter from wastewater using anaerobic moving bed biofilm reactor: A performance analysis

Abstract

In this study, an anaerobic moving bed biofilm reactor (AMBBR) was designed to biodegrade atrazine under mesophilic (32 °C) condition and then it was evaluated for approximately 1 year. After biofilm formation, acclimation, and enrichment of microbial population within the bioreactor, the effect of various operation conditions such as changes in the concentration of influent atrazine and sucrose, hydraulic retention time (HRT), and salinity on the removal of atrazine and chemical oxygen demand (COD) were studied. In optimum conditions, the maximum removal efficiency of atrazine and COD was 60.5% and 97.4%, respectively. Various models were developed to predict the performance of atrazine removal as a function of HRT during continuous digestion. Also, coefficients kinetics was studied and the maximum atrazine removal rate was determined by Stover - Kincannon model (rmax = 0.223 kgATZ/m3d). Increasing salinity up to 20 g/L NaCl in influent flow could inhibit atrazine biodegradation process strongly in the AMBBR reactor; whereas, the reactor could tolerate the concentrations less than 20 g/L easily. Results showed that AMBBR is feasible, easy, affordable, so suitable process for efficiently biodegrading toxic chlorinated organic compounds such as atrazine. There was no accumulation of atrazine in the biofilm and the loss of atrazine in the control reactor was negligible; this shows that atrazine removal mechanism in this system was due to co-metabolism.