Abstract
Surface wave tests are non-invasive seismic techniques that have traditionally been used to determine the shear wave velocity (i.e. shear modulus) profile of soil deposits and pavement systems. Recently, Rix et al. [J. Geotech. Geoenviron. Engng 126 (2000) 472] developed a procedure to obtain near-surface values of material damping ratio from measurements of the spatial attenuation of Rayleigh waves. To date, however, the shear wave velocity and shear damping ratio profiles have been determined separately. This practice neglects the coupling between surface wave phase velocity and attenuation that arises from material dispersion in dissipative media. This paper presents a procedure to measure and invert surface wave dispersion and attenuation data simultaneously and, thus, account for the close coupling between the two quantities. The methodology also introduces consistency between phase velocity and attenuation measurements by using the same experimental configuration for both. The new approach has been applied at a site in Memphis, TN and the results obtained are compared with independent measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.