Simultaneous imaging of fuel, OH, and three component velocity fields in high pressure, liquid fueled, swirl stabilized flames at 5 kHz

Abstract

This paper describes implementation of simultaneous, high speed (5 kHz) stereo PIV, OH and fuel-PLIF in a pressurized, liquid fueled, swirl stabilized flame. The experiments were performed to characterize the flow field, qualitative heat release and fuel spray distributions, and flame dynamics. Acquiring high speed OH-PLIF in pressurized, liquid fuel systems is difficult due to the strong overlap of the fuel's absorption and emission spectra with the OH fluorescence spectrum. To overcome difficulties associated with the overlap, the OH and fuel fluorescence signals were partially separated by using two cameras with differing spectral filters and data acquisition timing. Upon data reduction, regions containing fuel, OH and a mixture of fuel and OH are identified. Instantaneous and time-averaged results are discussed showing the flow field, flame position and dynamics, and spray distribution from the fuel signal for two multi-component liquid fuels, at two inlet temperatures and three pressures. These results are used to infer several important observations on coupled flow and flame physics. Specifically, the flame is “M-shaped” at higher preheat temperature and higher fuel/air ratio, as opposed to no visible reaction on the inside of the annular fuel/air jet at low temperature and fuel/air ratio conditions. While such fundamentally different flame topologies in gaseous, premixed flames are well known, these results show that there are also different families of flame shapes and heat release distributions in spray flames. In addition, the flame position with respect to the flow is different for the liquid-fueled flame than for gaseous, premixed flames—in premixed flames with this geometry, the flame lies in the low velocity shear layer separating the reactants and the recirculating products. In contrast, the flame location is controlled by the spray location in this spray flame, as opposed to the shear layer. For example, reactions are observed near the nozzle outlet in the core of the high velocity annular jet, something which would not be observed in the premixed flame configuration. Also of interest is the near invariance of the key flow features—such as jet core trajectory or shear layer locations—to the operating condition changes for this study, even as the spray penetration and distribution, and flame position change appreciably.