Abstract

Benthic marine dioflagellate microalgae belonging to the genus Prorocentrum are a major source of okadaic acid (OA), OA analogues and polyketides. However, dinoflagellates produce these valuable toxins and bioactives in tiny quantities, and they grow slowly compared to other commercially used microalgae. This hinders evaluation in possible large-scale applications. The careful selection of producer species is therefore crucial for success in a hypothetical scale-up of culture, as are appropriate environmental conditions for optimal growth. A clone of the marine toxic dinoflagellate P. belizeanum was studied in vitro to evaluate its capacities to grow and produce OA as an indicator of general polyketide toxin production under the simultaneous influence of temperature (T) and irradiance (I0). Three temperatures and four irradiance levels were tested (18, 25 and 28 °C; 20, 40, 80 and 120 µE·m−2·s−1), and the response variables measured were concentration of cells, maximum photochemical yield of photosystem II (PSII), pigments and OA. Experiments were conducted in T-flasks, since their parallelepipedal geometry proved ideal to ensure optically thin cultures, which are essential for reliable modeling of growth-irradiance curves. The net maximum specific growth rate (µm) was 0.204 day−1 at 25 °C and 40 µE·m−2·s−1. Photo-inhibition was observed at I0 > 40 μEm−2s−1, leading to culture death at 120 µE·m−2·s−1 and 28 °C. Cells at I0 ≥ 80 µE·m−2·s−1 were photoinhibited irrespective of the temperature assayed. A mechanistic model for µm-I0 curves and another empirical model for relating µm-T satisfactorily interpreted the growth kinetics obtained. ANOVA for responses of PSII maximum photochemical yield and pigment profile has demonstrated that P. belizeanum is extremely light sensitive. The pool of photoprotective pigments (diadinoxanthin and dinoxanthin) and peridinin was not able to regulate the excessive light-absorption at high I0-T. OA synthesis in cells was decoupled from optimal growth conditions, as OA overproduction was observed at high temperatures and when both temperature and irradiance were low. T-flask culture observations were consistent with preliminary assays outdoors.

Highlights

  • Microalgal dinoflagellates are a major source of structurally diverse bioactive natural products and toxins with potential uses in biomedical, toxicological and pharmacological research [1]

  • Since the physiology of P. belizeanum is yet to be investigated as a required stage of a potential bioprocess, the aim of this work was to evaluate the simultaneous influence of irradiance and temperature on growth kinetics, maximum photochemical yield of the photosystem II (PSII), pigment profile and okadaic acid (OA) production, by using several combinations of the two variables

  • Our cultures can be considered optically thin, i.e., it is unlikely that self-shading affected the experimental results reported. This issue is critical in the modeling of the P-I curves. These curves derived from laboratory studies are commonly used to predict biomass productivity in photobioreactors or natural habitats, where the cell density is high, and the effect of light attenuation

Read more

Summary

Introduction

Microalgal dinoflagellates are a major source of structurally diverse bioactive natural products and toxins with potential uses in biomedical, toxicological and pharmacological research [1]. The production of 150 g of a certain dinoflagellate toxin is estimated to require a culture broth volume of between 103 (Alexandrium minute) and 105 m3 (Gambierdiscus toxicus) [4]. This is far larger than the volume of the fermentation broth needed to produce the same quantity of a typical antibiotic, for example. The concentration of a target compound can be enhanced by modifying and combining different levels of culture of abiotic factors

Objectives
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call