Simultaneous determination of asenapine and valproic acid in human plasma using LC–MS/MS: Application of the method to support pharmacokinetic study

Abstract

Combination of asenapine with valproic acid received regulatory approval for acute treatment of schizophrenia and maniac episodes of bipolar disorders. A simple LC–MS/MS method was developed and validated for simultaneous quantification of asenapine and valproic acid in human plasma. Internal standards were added to 300μL of plasma sample prior to liquid–liquid extraction using methyl tertiary butyl ether (MTBE). Chromatographic separation was achieved on Phenomenex C18 column (50mm×4.6mm, 5μm) in isocratic mode at 40°C. The mobile phase used was 10mM ammonium formate–acetonitrile (5:95, v/v) at a constant flow rate of 0.8mL/min monitored on triple quadrupole mass spectrometer, operating in the multiple reaction monitoring (MRM) mode. The injection volume used for LC–MS/MS analysis was 15μL and the run time was 2.5min. These low run time and small injection volume suggest the high efficiency of the proposed method. The method was validated over the concentration range of 0.1–10.02ng/mL and 10–20,000ng/mL for asenapine and valproic acid respectively. The method recoveries of asenapine (81.33%), valproic acid (81.70%), gliclazide (78.45%) and benzoic acid (79.73) from spiked plasma samples were consistent and reproducible. The application of this method was demonstrated by a pharmacokinetic study in 8 healthy male volunteers with 5mg asenapine and 250mg valproic acid administration.