Simultaneous determination of aerosol- and surface characteristics from top-of-atmosphere reflectance using MERIS on board of ENVISAT

Abstract

The determination of aerosol optical thickness (AOT) from nadir scanning multi-spectral radiometers, like SeaWiFS, MERIS or MODIS, requires the separation of spectral atmospheric and surface properties. Since SeaWiFS and MERIS do not provide information at 2.1 μm, like MODIS, the estimation of the surface reflectance cannot be made by the cross correlation approach described by Kaufman et al., 1997. The BAER approach (Bremen AErosol Retrieval), von Hoyningen-Huene et al., 2003, uses a linear mixing model of spectra for ‘green vegetation’ and ‘bare soil’, tuned by the NDVI, determining an apparent surface to enable this separation of aerosol and surface properties from VIS and NIR channels. Thus AOT can be derived over a wide range of land surfaces for wavelengths <0.67 μm. Using MERIS L1 data over Europe, the AOT retrieved is comparable with ground-based observations, provided by AERONET. Regional variation of AOT can be observed, showing the atmospheric variability for clear sky conditions by: large scale variation of aerosol turbidity, regional pollution, urban regions, effects of contrails and cases of aerosol-cloud interaction. Simultaneously with the spectral AOT also spectral surface reflectance is obtained, where all atmospheric influences have been considered (molecules, aerosols and absorbing gases (O 3)) for channels with wavelengths <0.67 μm. The AOT is extrapolated by Angström power law to NIR channels and the atmospheric correction for land surface properties is performed, enabling the further investigation of land use and spectral land properties.