Simulations of Droplet Coalescence in Simple Shear Flow

Abstract

Simulating droplet coalescence is challenging because small-scale (tens of nanometers) phenomena determine the behavior of much larger (micrometer- to millimeter-scale) droplets. In general, liquid droplets colliding in a liquid medium coalesce when the capillary number is less than a critical value. We present simulations of droplet collisions and coalescence in simple shear flow using the free-energy binary-liquid lattice Boltzmann method. In previous simulations of low-speed collisions, droplets coalesced at unrealistically high capillary numbers. Simulations of noncoalescing droplets have not been reported, and therefore, the critical capillary number for simulated collisions was unknown. By simulating droplets with radii up to 100 lattice nodes, we determine the critical capillary number for coalescence and quantify the effects of several numerical and geometric parameters. The simulations were performed with a well-resolved interface, a Reynolds number of one, and capillary numbers from 0.01 to 0.2. The ratio of the droplet radius and interface thickness has the greatest effect on the critical capillary number. As in experiments, the critical capillary number decreases with increasing droplet size. A second numerical parameter, the interface diffusivity (Péclet number) also influences the conditions for coalescence: coalescence occurs at higher capillary numbers with lower Péclet numbers (higher diffusivity). The effects of the vertical offset between the droplets and the confinement of the droplets were also studied. Physically reasonable results were obtained and provide insight into the conditions for coalescence. Simulations that match the conditions of experiments reported in the literature remain computationally impractical. However, the scale of the simulations is now sufficiently large that a comparison with experiments involving smaller droplets (≈10 μm) and lower viscosities (≈10(-6) m(2)/s, the viscosity of water) may be possible. Experiments at these conditions are therefore needed to determine the interface thickness and Péclet number that should be used for predictive simulations of coalescence phenomena.