Abstract
In order to solve the icing phenomenon of mine wind gap, a physical model of L-type gravity heat pipe was designed in combination with calculation of shaft operating condition, which based on the new idea that geothermal energy of thermostatic formation is used as driving heat source of heat pipe for shaft antifreeze. The numerical simulation showed that the condensation end temperature of the heat pipe could reach 275K. The heat pipe optimization simulation was carried out for the length of the condensation and insulation section of the heat pipe. When the condensing section is 5 m, the effect is the best. The results showed that the temperature at the condenser end of the heat pipe was increased by 275.6K after optimization. The optimized scheme for extracting heat energy from thermostat by heat pipe has a good effect.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Earth and Environmental Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
