Simulation of the surface and volume stress in the contact archwire/bracket for classical friction and critical contact angle

Abstract

AbstractAimThe occlusion of the teeth is affected due to the appearance of micro-cracks resulting from maximum stresses in the contact zones between the wire and the bracket under normal and tangential loading. The objective of this study is to evaluate the surface and volume constraints in the presence of bonding and partial sliding zones on the contact surface between wires and supports. Knowledge of these stress fields will make it possible to better limit the surfaces where most of the micro-cracks occur. Indeed, the evaluation of the stress will facilitate the modelling or application of established micro crack models on this subject, because the initiation of micro-cracks often appears on the contact surface or just below it.Materials and methodsIn this study, the two most common situations of contact between the wire and the bracket were studied; the first corresponds to the situation where the wire is positioned in the center of the support (classic friction), and the second corresponds to the situation where the inclined wire touches the ends of the supports (critical contact angle).The MATHCAD software was used to simulate the damage zones for normal loading in the two cases studied (classic friction, critical contact angle). We proposed a Hertzian loading for the first case and a linear loading for the second case. Also, the effect of the additional load during wire tightening applied by the orthodontist was studied.ResultsThe charge concentration is located above the contact zone, of the order of 0.3P0 (pressure per unit of arbitrary normal length), according to Mathcad simulation results. The adhesion zone/micro-slip zone contact generates the largest tangential load, which is directed towards the side experiencing the most stress. We also observed that the stick area shifts towards the recessed side when the additional load is applied. Additionally, comparing the configurations, the critical contact angle resulted in a higher maximum shear stress.