Simulation of supersonic jet flow past a blunt body in a laboratory experiment using computer vision

Abstract

The complex flow of a supersonic jet (Mach number 2.4–2.5) around the blunt aerodynamic body (consisting of a cylinder with a diameter of 16 mm and a truncated cone) was studied using the high-speed shadowgraph technique and computer vision-based visual data processing. The problem considered is directly related to the rocket and space systems stages safe separation problem in a sufficiently dense atmosphere. For systems with a sequential arrangement of stages, their separation often occurs under the rocket engine jet action. The occurrence of lateral forces in violation of axial symmetry can lead to overturning of the discarded stage and undesirable interaction with the outgoing stage. The goals of the paper were to study the pulsation characteristics of the incoming supersonic jet streamlining the body, as well as the pulsations of the bow shock wave in both axisymmetric and asymmetric flows. The recording frame rate in the experiments was up to 775 000 fps. Computer vision and various machine learning approaches were used to process a large number of shadowgraph images. Canny edge detection and Hough transform, as well as a convolutional neural network (CNN) based on YOLOv2 architecture, were used to automatically track the position of the bow shock relative to the body. Jet sound generation was studied - the amplitude dependence on the distance from the nozzle and the evolution in time. The position of the bow shock relative to the streamlined body and flow pulsations over time were analyzed. Bow shock pulsation spectra at zero angle of attack were compared to those at a small angle of attack (α = 2.5°–3°). The power spectral density was also estimated. The slope of the spectra for the zero angle of attack case was found to be horizontal and the spectra for the small angle of attack case had a slope close to −5/3. The strongest of the measured bow shock frequencies were found to be close to those of the jet mixing layer pulsations. The hardware signal spectrum was also measured and this signal can be considered as noise. The described approach makes it possible to obtain the physical characteristics of the flow at any point of interest. It was also shown that the automation of flow visualization experiments using computer vision techniques allows to increase the speed of data processing and obtaining new physical information, which may be important for engineers developing aircraft and spacecraft technologies.