Simulation of soil cutting blade wear

Abstract

The results of a laboratory study of the wear patterns of blades of tillage parts are presented. To substantiate the model of soil-cutting blade wear in laboratory studies. Applied installation, providing rectilinear movement of the sample, one-time interaction of the blade with the particles of abrasive mass, and reproducing chip separation, inherent in most loamy soils. The dependence of the angle of inclination of the occipital chamfer to the bottom of the furrow, the width of the occipital chamfer and blade wear along the length of the sample from the cutting path, taken in studies for the main parameters of wear, were obtained. It was found that with increasing depth of cut, the intensity of wear increases, but when there are irregularities and undulations of the bottom of the furrow, it decreases due to the increase in the cutting path with lower loads due to the alternation of depressions and protrusions at the bottom of the furrow. With increasing hardness of the abrasive mass, the intensity of wear of the blade increases, at the same time the value of the stabilized angle of the occipital chamfer to the bottom of the furrow decreases, due to changes in the wear mechanism. With increasing cutting speed, the intensity of blade wear increases due to increased soil resistance forces and specific energy expended on its deformation and destruction. It was shown that the abrasive model of the soil corresponds to the real loamy soil for the study of wear of cutting elements. The expansion of the characteristics of the soil model peculiar to «nature» is due to the inclusion of additional components, in particular ceresin and vaseline, in the composition of the base "paraffin + quartz particles".