Abstract
AbstractIt is very difficult to produce thin wall complex castings of the Ni3Al‐based alloy by investment casting. Defects such as incomplete mold filling and hot tears appear commonly. In this paper, physical parameters of Ni3Al‐based alloy are obtained by experiments and simulations using JmatPro software. The calculation results of physical parameters are credible by comparing with test results and can be used in the pre‐processing of casting simulaton software ProCAST of thin wall castings. Gating and feeding system is optimized to decrease hot tearing tendentiousness and ensure filling ability according to casting simulation results.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
