Abstract
Radio frequency (RF) microelectromechanical (MEMS) switches and filters are extensively used for telecommunication in the last few years due to their high performance compared to the other microelectronics switches available in present electronic world. Considering the cost effectiveness and high performance, conventional switches are replaced by RF MEMS switch in mobile communication technology. In order to open circuit in transmission line or simply to get a short circuit, RF MEMS uses mechanical movement and it has immense privileges of low-insertion loss, good linearity and high isolation. To achieve low voltage, switching frequency and low insertion loss, a RF MEMS switch is designed in this study using ANSYS. Beam with meander have been model for structural and pull in analysis. For pull in analysis 2.5 V to 6 V has been applied. The best suitable deflection 2.8536 µm has been achieved at the 5 V applied pull in voltage with maximum equivalent stress 4.5278 MPa.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
