Simulation of daily energy budget and mean soil temperatures at an arid site

Abstract

Soil temperature is often inadequately based upon relatively few measurements at widely dispersed locations. Within arid regions, such as the desert southwestern United States, soils, microclimates, and thus soil temperature may be markedly heterogeneous. Because extensive measurement of soil temperature is often not feasible, models are needed that simulate soil temperature based on readily available soil survey and “above-ground” weather information. This paper describes a simple energy-budget based model for simulating daily mean temperatures within a bare arid land soil. The model requires basic information on soil physical properties, and daily weather data including air temperature, windspeed, rainfall, and solar radiation to calculate daily surface energy budget components and surface temperature. One of two alternative numerical methods is then used to calculated subsurface temperatures. Tests of the model using 1987 daily temperature data from an arid site at Yuma, Arizona resulted in root mean square deviations within 1.4°C between daily modeled and measured temperatures at both 0.05 and 0.10 m depths. Sensitivity analysis showed modeled temperatures at 0.05 m depth to be most sensitive to parameters affecting the surface energy balance such as air temperature and solar radiation. Modeled temperatures at 1.0m depth were relatively more sensitive to initial temperature conditions and to parameters affecting distribution of energy within the profile such as thermal conductivity.