Simulation of a flood producing rainfall event of 29 July 2010 over north-west Pakistan using WRF-ARW model

Abstract

Simulation of a flood producing rainfall event of 29 July 2010 over north-west Pakistan has been carried out using the Weather Research and Forecasting (WRF) model. This extraordinary rainfall event was localized over north-west Pakistan and recorded 274 mm of rainfall at Peshawar (34.02°N, 71.58°E), within a span of 24 h on that eventful day where monthly July normal rainfall is only 46.1 mm. The WRF model was run with the triple-nested domains of 27, 9, and 3 km horizontal resolution using Kain–Fritsch cumulus parameterization scheme having YSU planetary boundary layer. The model performance was evaluated by examining the different simulated parameters. The model-derived rainfall was compared with Pakistan Meteorological Department–observed rainfall. The model suggested that this flood producing heavy rainfall event over north-west region of Pakistan might be the result of an interaction of active monsoon flow with upper air westerly trough (mid-latitude). The north-west Pakistan was the meeting point of the southeasterly flow from the Bay of Bengal following monsoon trough and southwesterly flow from the Arabian Sea which helped to transport high magnitude of moisture. The vertical profile of the humidity showed that moisture content was reached up to upper troposphere during their mature stage (monsoon system usually did not extent up to that level) like a narrow vertical column where high amounts of rainfall were recorded. The other favourable conditions were strong vertical wind shear, low-level convergence and upper level divergence, and strong vorticity field which demarked the area of heavy rainfall. The WRF model might be able to simulate the flood producing rainfall event over north-west Pakistan and associated dynamical features reasonably well, though there were some spatial and temporal biases in the simulated rainfall pattern.