Abstract
In this paper, a method for the aerosol application of polymers to fabric surfaces is discussed. A lot of thermoplastic polymer materials during application have the property of hardening and the formation of glue lumps. This leads to a decrease in the quality of the coating applied. In view of the fact that aerosol coating is undoubtedly advantageous, it required improvement. Modeling of polymer flow through the nozzle was perform to determine the optimal application distance. The experimental part consisted of applying a solution of a polyvinyl chloride polymer to a fabric using an ultrasonic radiator on a diffuser. Just for comparison, samples without the connection of the radiator were perform. Politec 3D scanner equipment used to determine deformation changes. This study has a weight for the further development and improvement of coating devices.DOI: http://dx.doi.org/10.5755/j01.mech.24.1.20215
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
