Abstract
When the non-effectively grounding network of single-phase ground fault happens, the voltage, the current, the zero-sequence voltage and the zero-sequence current have a special change and this problem has been the focus of research attention. Subsequently, it has important effect about the analysis of power system fault characteristics and choice of protection scheme to modeling system of single-phase fault for little grounding current network and to use the zero sequence current amplitude and phase of identifying the fault line and fault phase based on MATLAB software platform in this paper.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Earth and Environmental Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
