Abstract
In this paper, fundamental equations for jetting dispenser are presented to express the influence of adhesive pressure, nozzle diameter, and needle movement law, and the equations are then verified by flow behavior simulation. Subsequently, a novel jetting dispenser system is built to finish experiments about the mentioned influence parameters, and simulation results verify the regularities from experiment are correct. Flow velocity in the central nozzle will be faster and radius of the droplet will be bigger if the pressure in the chamber became higher, flow velocity in the central nozzle will be constant and the radius of the droplet will be bigger if the dead time became longer, and bigger nozzle diameter can lead to faster flow velocity in the central nozzle and bigger droplet. Besides, these mentioned works prove that our designed jetting dispenser is practical and useful for adhesive jetting.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
