Abstract
This paper presents the simulation and design of Neutral Point Type (NPT) converters that have been used to increase power factor near one (1) which is unity. The circuit of the simulation has been design using Simulink MATLAB. The circuit was set to 50 kHz to generate Pulse Width Modulation (PWM) with carrier signal and comparing it with the reference signal. By adjusting the capacitor in the main circuit, the result of the simulation shows that the input current and voltage were in phase which is unity power factor while the output current and voltage produced having a low ripple. Thus, the simulation shows that the Neutral Point Buck type converter is suitable for maximizing power factor close to unity (1).
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Innovative Technology and Exploring Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
