Abstract
Simulation model for sinter mixture's drying process was established and validated with the tunnel drier experiment. On this basis, hot blast temperature and flow rate, sinter bed's porosity factor and particle diameter are analyzed. The result shows that the effects of hot blast temperature and flow rate are far larger than the effects of sinter bed's porosity factor and particle diameter. Hot blast temperature obviously influences the drying process before 200?, while little or no effect after 300?. For the suitable sinter moisture content, hot blast flow rate of 1.5m/s or more is recommended during 200? to 250?.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
