Simple Approximate Solutions for Dynamic Response of Suspension System

Abstract

An approximate simplified analytic solution is proposed for the one DOF (degree of freedom) static and dynamic displacements alongside the stiffness (dynamic and static) and damping coefficients (minimum and maximum/critical values) of a parallel spring-damper suspension system connected to a solid mass-body gaining its energy by falling from height h. The analytic solution for the prescribed system is based on energy conservation equilibrium, considering the impact by a special G parameter. The formulation is based on the works performed by Timoshenko (1928), Mindlin (1945), and the U. S. army-engineering handbook (1975, 1982). A comparison between the prescribed studies formulations and current development has led to qualitative agreement. Moreover, quantitative agreement was found between the current prescribed suspension properties approximate value - results and the traditionally time dependent (transient, frequency) parameter properties. Also, coupling models that concerns the linkage between different work and energy terms, e.g., the damping energy, friction work, spring potential energy and gravitational energy model was performed. Moreover, approximate analytic solution was proposed for both cases (friction and coupling case), whereas the uncoupling and the coupling cases were found to agree qualitatively with the literature studies. Both coupling and uncoupling solutions were found to complete each other, explaining different literature attitudes and assumptions. In addition, some design points were clarified about the wire mounting isolators stiffness properties dependent on their physical behavior (compression, shear tension), based on Cavoflex catalog. Finally, the current study aims to continue and contribute the suspension, package cushioning and containers studies by using an initial simple pre – design analytic evaluation of falling mass- body (like cushion, containers, etc.).