Abstract

Tetradecyltrimethyl ammonium ions (C14TA+) were used as trace additives in a seed solution to block the (111) seed surface so as to govern the growth direction and pathway, leading to the formation of Ag nanoplates. The spectra of the obtained nanoplate solution showed a high intensity peak, attributed to the in-plane dipole resonance, and a low-intensity peak at 400nm. By decreasing the amount of C14TA+-adsorbed seed amount from 20μL to 15μL and 5μL the mean height of triangular nanoplates was altered from ∼96nm to ∼130nm and ∼177nm. The in-plane dipole resonance peak, which corresponds to the change in the mean height, shifted from 655nm to 740nm and 807nm, respectively. To investigate the feasibility of practical application of the proposed method, the prepared nanoplates were used as an electrocatalyst to sense a glucose oxidation reaction (GOR). A cyclic voltammogram of the nanoplates showed two significant peaks during the cathodic sweep, indicating that the anodic oxides provide active sites and have high GOR activity. Simultaneously, the results measured by potential deposition of Pb show the nanoplates have electrochemical surface areas (ESAs) of 96nm>130nm>177nm. The higher activity on the 96nm sized nanoplates is attributed to the fact they have the largest ESA. Remarkably, the prepared nanoplates show high potential as glucose sensors, in that the 96nm nanoplates showed 0.527mAmM−1cm−2 sensitivity for glucose.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call