Abstract

In this article, we investigate the use of silicon-based diode for millimeter-wave noise generation. A test bench setup was characterized to perform broadband noise measurements up to 325 GHz. A noise receiver is assembled and its Noise Figure (NF) was extracted using cryogenic Hot/Cold measurements. A unitravelling carrier photodiode (UTC-PD) is used as a noise source and the Excess Noise Ratio (ENR) is extracted using the Y-method. The latter was used as a reference for 300 GHz noise generation. The ENR value of the UTC-PD is then compared to that of a silicon based integrated diode noise source, where the ENR value was also extracted using the same receiver structure, to evaluate the integrated diode performance up to 325 GHz where it will be used to carry out noise measurements up to this frequency range.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.