Silica Precipitation in Acidic Solutions: Mechanism, pH Effect, and Salt Effect

Abstract

This study is the first to show that silica precipitation under very acidic conditions ([HCl] = 2-8 M) proceeds through two distinct steps. First, the monomeric form of silica is quickly depleted from solution as it polymerizes to form primary particles approximately 5 nm in diameter. Second, the primary particles formed then flocculate. A modified Smoluchowski equation that incorporates a geometric population balance accurately describes the exponential growth of silica flocs. Variation of the HCl concentration between 2 and 8 M further showed that polymerization to form primary particles and subsequent particle flocculation become exponentially faster with increasing acid concentration. The effect of salt was also studied by adding 1 M chloride salts to the solutions; it was found that salts accelerated both particle formation and growth rates in the order: AlCl(3) > CaCl(2) > MgCl(2) > NaCl > CsCl > no salt. It was also found that ionic strength, over cation identity, determines silica polymerization and particle flocculation rates. This research reveals that precipitation of silica products from acid dissolution of minerals can be studied apart from the mineral dissolution process. Thus, silica product precipitation from mineral acidization follows a two-step process--formation of 5 nm primary particles followed by particle flocculation--which becomes exponentially faster with increasing HCl concentration and with salts accelerating the process in the above order. This result has implications for any study of acid dissolution of aluminosilicate or silicate material. In particular, the findings are applicable to the process of acidizing oil-containing rock formations, a common practice of the petroleum industry where silica dissolution products encounter a low-pH, salty environment within the oil well.