Abstract

Two-photon quantum interference at a beam splitter, commonly known as Hong–Ou–Mandel interference, is a fundamental demonstration of the quantum mechanical nature of electromagnetic fields and a key component of various quantum information processing protocols. The phenomenon was recently demonstrated with microwave-frequency photons by Lang et al (2013 Nature Phys. 9 345–8). This experiment employed circuit QED systems as sources of microwave photons, and was based on the measurement of second-order cross-correlation and auto-correlation functions of the microwave fields at the outputs of the beam splitter using linear detectors. Here we present the calculation of these correlation functions for the cases of inputs corresponding to: (i) trains of pulsed Gaussian or Lorentzian single microwave photons and (ii) resonant fluorescent microwave fields from continuously driven circuit QED systems. In both cases, the signature of two-photon quantum interference is a suppression of the second-order cross-correlation function for small delays. The experiment described in Lang et al (2013) was performed with trains of Lorentzian single photons, and very good agreement with experimental data is obtained. The results are relevant not only to interference experiments using circuit QED systems, but any such setup with highly controllable sources and time-resolved detection.

Highlights

  • Rather than assuming the circuit QED systems are configured as pulsed single-photon sources, we can assume that they are continuously driven and operated in the regime of resonant photon blockade [23]

  • Since the intensity of a field is proportional to the number of photons it contains, we shall refer to correlation functions of the form of equation (2) as intensity correlation functions

  • The physics of each source is essentially the physics of resonance fluorescence [31, 32], with additional dephasing included. Note that this twolevel system (TLS) is formed from the coupled system, and is not the ‘qubit’ typically employed for superconducting quantum information processing

Read more

Summary

Current address

We present the calculation of the microwave field secondorder auto-correlation and cross-correlation functions at the output of the beam splitter for input fields composed of trains of Gaussian photons, trains of Lorentzian photons and resonance fluorescence from detuned, continuously driven sources. These results are relevant to circuit QED systems and microwave fields, but to any interference experiment with highly controllable sources and time-resolved detection.

Intensity correlation functions
Phase-dependent moments
Second-order correlation functions
Temporal modes and correlation functions
Single Gaussian photons
Single Lorentzian photons
Trains of single photons
Filtered response
Introduction
Output correlation functions
Resonant photon blockaded inputs
Photon polarization
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call