Abstract
Since one GRS used for Control and Non-Payload Communication (CNPC) of Unmanned Aerial Vehicle (UAV) cannot support all operational ranges of an UAV, the handover technology of CNPC is essential to operate an UAV in a wide range. However, the CNPC physical layer standard of Radio Technical Commission for Aeronautics (RTCA) does not have a reference signal for measuring the signal strength of a neighboring base station used for handover decision in an existing mobile communication system. Therefore, in this paper, we propose a method to transmit measurement signals for stable handover of CNPC. The proposed method starts transmission of the measurement signal when the UAV enters the handover zone for the preventing waste of power and generates the measurement signal using the same data that is transmitted through the currently connected Ground Radio Station (GRS) for the preventing packet loss during the handover operation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.