Abstract
The research and technical community have designated a band of 7GHz between 57 and 64GHz for short-range wireless communications. This paper utilizes a simple and cost effective technique for generating a 60GHz millimeter-wave (mm-wave) signal using an optical comb source based on a gain-switched laser (GSL). This research investigates the effects unwanted comb lines have on the overall system performance with 2.5Gb/s data transmission. To do this, a programmable optical filter is used to suppress the unwanted comb lines to varying levels. Bit-error rate (BER) measurements were carried out against received optical power to demonstrate the detrimental effects the unwanted comb lines have on the modulated mm-wave signal when not sufficiently suppressed. As chromatic dispersion is a limiting factor to the system's transmission distance, this work also investigates pre-compensation for dispersion utilizing the programmable group delay capabilities of the programmable optical filter, demonstrating the ability to extend the transmission distance by 12km. All experimental results obtained are reinforced through simulation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
